MKII Temperature Controller (Heat & Cool)

The Keg King MKII temperature controller is a device that allows you to control the temperature of your fermentation or distillation process with precision and ease. It has two plugs, one for heating and one for cooling, so you can connect a heating pad, a fridge, a freezer, or any other device that can regulate the temperature of your vessel. You can set the desired temperature range and the controller will automatically switch on and off the heating or cooling device as needed.

Whether you're brewing, distilling, curing meat, fermenting beverages or runnig an aquarium, Keg King MKII advanced temperature controllers are packed with excellent features for anyone looking to get accurate temperatures when heating and cooling.

Our MKII Temp Controller Allows two new advanced features:

Programable Temperature Profile

Setup a temperature profile so you can program the temp controller to step up and down the temperature over time.

For optimum fermentation conditions you can program this smart temperature controller to start fermenting at one temperature, increase the temperature after a number of days then crash chill. This can be achieved without any intervention at all. Just set and forget.

When brewing,  use the MKII Temp Controller to step up the temperature of your mash tun. The controller will automatically step the temperature up and down as you please. 

Distillation Mode

If you have ever attempted distillation, you'll know how painful it is to sit there waiting and watching the still drip.

The Keg King MKII Temp Controller can look after the distillation process for you while you relax. With Distillation mode, once the controller reaches the set temperature, the cooling circuit is turned off and will not turn back on when the temperature drops.

Specifications:
- Temperature probe size is 5.5mm

- High accuracy 0.1 degree C.
- Dual plugs so you can control heating and cooling devices with the one controller
- 2 x 10amp sockets on rear; one for heating and one for cooling
- Works from -45C up to 120C
- Comes with FULLY waterproof probe so you can immerse the probe in water.
- Uses “50k ohm” Probe
- Manufactured in compliance with Australian Standards

NOTE: To reset the controller to default/factory settings, hold the up and down arrow down for 6 seconds.